Pinnacle-systems DR Manual de usuario descargar pdf (Pagina 42)

D - 1

Appendix “D”

USB Diagnostic Codes

Model MG or DR USB Diagnostic Codes: Master Controls USB port

Note: You must install the Silabs CP210x USB driver on your windows PC. Check your Device

Manager for Silabs COM port#. You read the port at 230400 Baud 8N1

Char

Description

B or b

First or Second Pylon set Blocked

repeats when # of blocked beams changes

M or m

First or Second Pylon set Blocked during MUTE-OUT condition

Guard stays GREEN

C or c

First or Second Pylon set Cleared after a Block

E or e

First or Second Pylon set no Blocked beams during MUTE-OUT condition

Light Curtain in MUTE-OUT (Guard was GREEN before going into MUTE-OUT)

Light Curtain no longer in MUTE-OUT

Check EEPROM

Start & Stop ReWriting EEPROM

Should only happen 1

time programmed

Fault found active in EEPROM at Startup

Previously powered down with an

uncleared Fault

AutoBlank load

Should always see this

“Soft Ver= R34r.1012.MG”

Scroll this string on LED display

Only RST F1 push can interrupt this

Version Display scroll finished

“RST”

String on LED display

Then jmp to FAULT routine

Enter Fault() routine

x: 0=Slave in Fault() routine, 1=Slave not in Fault() routine

Should be F0

Writing to EEPROM new Fault code

V<cr>

Clearing Active Fault

Someone Hit RESET button while in a Fault

x y

x & y: upper and lower bytes of Fault Code just cleared.

Displayed in HEX

Return from Fault() routine

Not first time returning

P<cr>

Return from Fault() routine

First time returning

9 lines of 2 byte HEX showing the last 9 Fault Codes

First to Last

Hold RESET button down at power-up

LED displays 9 fault codes

End of Fault

First Time return from FAULT()

Run Initial pylon TEST

One time after power-up only

xxxx m

Pylon length , performing SHORT LED test

1 SCAN of pylon

“Wait”

Done with initial SHORT LED SCAN

If numbers appear without an F, then problems communicating with Slave

Bad Auto Blank memory

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Comentarios a estos manuales

Sin comentarios

Pinnacle-systems DR Manual de usuario Pagina 42

Comentarios a estos manuales

Relacionado con productos y manuales para Relé Pinnacle-systems DR